Lil' Cobber Series Bike Lights

The Lil’ Cobber Twinpack is a top - notch commuter bike light set. The front and rear lights emit an amazing 330° of light, making you highly visible from every angle. Whether it's day or night, these lights are extremely effective at grabbing attention. If you're on the hunt for the best bike lighting for your daily commute, look no further. Operating the Lil’ Cobber is a breeze. Just long - press the single button to turn the light on or off, and a short press cycles through the modes. With an IP67 rating, it's 100% waterproof and can run for up to 40 hours. These lights are incredibly bright. The front light packs 110 lumens and the rear has 50 lumens. The efficient Chip on Board (COB) LEDs maintain maximum brightness for up to 90% of the battery life. It comes pre - programmed with 4 lighting modes. Mounting the Cobber is easy. It comes with tool - less removable silicone straps suitable for bars and seat posts with a diameter of 22 – 32mm and above, as well as a magnetic mount. There's also a large strap that fits tubes and head tube profiles with a circumference of up to 200mm. It includes a standard and Aero mount. Charging is hassle - free as it has an integrated USB plug that goes directly into USB ports. It takes 4 hours to charge. When the battery is low, a red ring lights up around the button. Once fully charged, the ring turns green and then goes off. Specs: Lil' Cobber Front Light: - Peak Lumens: 110 - Peak Runtime: 60hrs - Recharge Time: 4hrs - Mount: Silicon Strap - Weight: 25g - Dimensions: H: 22mm x W: 33mm x L:33mm Lil' Cobber Rear Light: - Peak Lumens: 50 - Peak Runtime: 40hrs - Recharge Time: 4hrs - Mount: Silicon Strap - Weight: 25g - Dimensions: H: 22mm x W: 33mm x L:33mm

Using the Lil' Cobber bike lights is super easy. To turn the light on or off, just give the single button a long press. A short press will let you cycle through the 4 pre - programmed lighting modes. When mounting, choose the right strap according to the diameter of your bike's bars, seat posts, tubes, or head tube profiles. The silicone straps are tool - less and removable, and there's also a magnetic mount for added convenience. For charging, simply plug the integrated USB plug into a USB port. It'll take about 4 hours to fully charge. Keep an eye on the ring around the button. When it's red, it means the battery is low. Once it turns green and then goes off, your lights are ready to go. As for maintenance, since the lights are 100% waterproof with an IP67 rating, you don't have to worry too much about water damage. But it's a good idea to clean them regularly with a soft, damp cloth to keep them looking good and functioning well. Also, avoid exposing the lights to extreme temperatures as this might affect the battery life and performance.