The Finish Line HALO Hot Wax Bag and Tool Set, weighing 600g, is a game - changer for your bike's drivetrain. The HALO Hot Wax chain lubricant is designed to boost drivetrain performance in both dry and wet conditions. It does this in three key ways. First, it greatly reduces the pull of abrasive contaminants, keeping your drivetrain cleaner. Second, it offers an unmatched reduction in drivetrain friction, making your ride smoother. Third, with its three elite - grade ingredients, it ensures you can go long distances between re - lubrication.
**Instructions**:
1. Find your master link and remove the chain (you'll need master link pliers). Clean and dry the chain thoroughly before the first use.
2. To melt the wax pellets, you can put the HALO bag in a pot of water and bring it to a gentle boil. Or, pour the pellets into a slow cooker.
3. Use the Immersion Tool in the bag to secure the chain. Scan the QR code for the best way to do this.
4. Once the wax is fully melted, take out the bag and place it on a covered work area.
5. Submerge the chain into the melted wax using the Immersion Tool.
6. Let the chain sit in the wax for at least 3 minutes to make sure it soaks into the chain bushings.
7. Take the chain out of the hot wax and hang it until it's dry (about 30 minutes). Note that some wax will drip.
8. After it's dry, move the chain around before putting it back on your bike. It's normal for some extra wax to flake off.
**Best Practices**: Keep the temperature below 220°F (104°C). Don't use an oven or microwave to melt the wax. Stay away from open flames. Wear gloves and eyewear. If you need to remove old wax from the chain, use boiling water.
This Finish Line HALO 600g hot wax bag and tool set is a great choice for your bike. To use it, first, find the master link on your chain and take it off with master link pliers. Make sure to clean and dry the chain well. Then, you can melt the wax pellets either by putting the HALO bag in boiling water or using a slow cooker. Once the wax is melted, use the Immersion Tool to secure and submerge the chain in the wax. Leave the chain in for at least 3 minutes. After that, take it out and let it dry for about 30 minutes. When it's dry, move the chain around a bit before re - attaching it to your bike. As for safety, keep the wax below 220°F (104°C), don't use an oven or microwave, and avoid open flames. Wear gloves and eyewear. If there's old wax on the chain, boiling water can help you remove it. This way, your bike's drivetrain will perform better and last longer.
